The maintenance of the automatic feeding mixer is also important in the whole project operation, and our work can be carried out normally only after the basic maintenance is completed. The following section will explain for you.
First place the sandpaper in ATF oil and soak it for about 30 minutes. Knock the valve body carefully to make the stuck valve stem fall from the valve chamber hole. It may be necessary to use a small screwdriver to lever it out.
Then the automatic feeding mixer truck shall be careful not to scratch the valve hole. Check whether the one-way valve rod has friction traces. Use # 600 sandpaper soaked in ATF oil to polish the burrs on the valve stem, then clean the valve stem in solvent and blow it dry with compressed air. Roll up half of # 600 sandpaper soaked in ATF oil, and insert it into the valve hole where the valve stem is stuck.
Gently twist the sandpaper to make it loose and tightly fit on the surface of the valve hole, and then push and pull while twisting the sandpaper to polish the valve hole. Pull out # 600 sandpaper. Clean the whole valve body in solvent and blow it dry with compressed air.
Coat the surface of the valve stem with ATF oil, and then drop it into the valve hole. The valve stem shall be able to fall into the bottom of the valve hole by its own weight. Otherwise, repeat Step and retest. If the valve stem is still stuck, replace the valve body.
Clean the valve rod and valve body with solvent for the automatic feeding mixer. Dry all parts with compressed air, then reassemble with ATF oil as lubricant.
After knowing the above maintenance knowledge, you can rest assured that our equipment will be overhauled. When you choose the automatic feeding mixer, we will have a special person to answer for you. It is recommended that the concrete storage tank and around the inlet and outlet should be cleaned at the end of the project to ensure that there is no cement and concrete caking. More relevant content will come to our website http://www.zkzsljbc.com Consult!