全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 常见问题 >

常见问题

小型搅拌车底盘系统有什么应急技巧?

作者:http://www.zkzsljbc.com 时间:2022-04-25

  底盘是小型搅拌车的支撑,将起到确保机械沿规定方向行驶的重要作用,所以,一旦底盘出现故障就将导致机械的运行出现问题。那么小型搅拌车底盘系统有什么应急技巧?
  The chassis is the support of the small mixing truck, which will play an important role in ensuring that the machine runs in the specified direction. Therefore, once the chassis failure will lead to problems in the operation of the machine. So what are the emergency skills of the small mixer chassis system?
  小型搅拌车制动分泵漏制动液或分泵管路折断,可在分泵管路接头处用铁皮、铜皮做个小垫子,将管路堵死,再旋紧螺钉,或者将断口夹扁、卷曲堵漏,使该轮不起制动用作。但这样做可能会造成单边制动,驾驶时要注意安全。
  Small agitator brake pump brake fluid leakage or pump pipe broken, can be in the pump pipe junction with iron sheet, copper make a small cushion, the pipeline is blocked, and then screw, or the fracture clamp flat, curly plugging, so that the wheel can not brake. But doing so may cause unilateral braking, so be careful when driving.
  小型搅拌车制动总泵缺制动液,可用酒精或白酒代替,特殊情况下可用清水代替。小型搅拌车制动皮碗发涨,将发涨的皮碗放在热水中浸泡10分钟-20分钟,将皮碗上的含油成分去掉,这样就可以使皮碗恢复原来的尺寸。
  The main brake pump of small agitator is short of brake fluid, which can be replaced by alcohol or liquor, or water in special cases. If the bowl of a small mixer is swollen, soak the bowl in hot water for 10-20 minutes to remove the oil on the bowl, so that the bowl can be restored to its original size.
  小型搅拌车离合器摩擦片烧蚀打滑,对烧蚀不太严重的摩擦片,可翻面使用。如烧蚀严重,可用棉布或帆布数层(其厚度应与原摩擦片一致),用钢丝或铁丝穿过钢片上的孔,使其固定。驾驶小型搅拌车时应做到起步平稳,换挡动作迅速。
  Small agitator clutch friction plate ablative slip, ablative friction plate is not too serious, can be turned over to use. If the ablation is serious, several layers of cotton cloth or canvas can be used (its thickness should be consistent with the original friction sheet), with steel wire or iron wire through the hole on the steel sheet, so that it is fixed. When driving a small mixer, it should start smoothly and shift gears quickly.
  横拉杆球节断损,在保险杠或其它不影响小型搅拌车行驶的地方,卸下一只与球节总长度相似的螺钉,取代断损的球节,装上转向节臂与螺母后,将螺钉露出部分用锤子铆好。若前差速器损坏,可将小型搅拌车轮毂接合盘拆下后继续行驶。
  Cross tie rod ball joint broken damage, in the bumper or other places that do not affect the driving of small mixing vehicles, remove a screw similar to the total length of the ball joint, replace the broken ball joint, install the steering knuckle arm and nut, the exposed part of the screw riveted with a hammer. If the front differential is damaged, the small agitator wheel hub joint plate can be removed and continue to run.
  基于这种认识,本文对小型搅拌车底盘系统应急技巧进行了分析,希望能够给您有效的帮助,更多内容就来网站www.zkzsljbc.com进行咨询吧!
  Based on this understanding, this paper analyzes the emergency skills of the small stirring truck chassis system, hoping to give you effective help. For more information, come to www.zkzsljbc.com for consultation!
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码