Since the feeding mixer if it is not well maintained in the process of use, it will be prone to problems, such as plugging. This problem is no small matter, we should pay attention to it.
The loading and unloading time is unreasonable: because the mixing truck can not be equipped with the level machine in the bin, it is basically controlled by time. How to set time parameters, loading and unloading time Settings are relatively simple. For the first time, set a short time and gradually increase according to each suction position. When the material level reaches the suction port time, subtract a reasonable time of one second. Discharging time is to ensure discharging one second more. The purpose of doing so has two advantages: one is the material level is too high, especially harmful to the filter element; The other is that you can clean the material every time.
Concrete feeder feeding mouth feeding volume is reasonable: the correct way is to form a certain air material mixing ratio in the suction mouth and air, under the impetus of concrete into the feeder evenly. Air flow. At this time, we need to design a bin with air supply function. It can be difficult if the material sits back too long. In this case, an oscillator needs to be installed on the bin to break up the lumped material.
It should be noted that the wrong maintenance method of the self-feeding mixer will not only reduce the quality of the equipment, but also damage some parts and components in serious cases, greatly reducing its service life. So I hope that through today's learning, you must not make the same mistake in the future.
So, if you relative to the equipment for more understanding, please come to our website http://www.zkzsljbc.com consultation!