It is very hot in summer. The internal noise and temperature of the automatic mortar cement mixer are very high. The low temperature in summer may be due to the temperature of the engine and oil.
1. There is not enough water in the car wash pool. Add water to the car wash.
2. If the suction port of the straw is blocked or blocked, you can check the straw and tighten it.
3. If the oil level in the fuel tank is too low and the air in the oil level has been pumped into the pump, hydraulic oil with the same label can be added.
4. If the pump mounting bracket is not rigid enough and vibration or noise occurs during operation, the oil pump mounting bracket can be reinforced.
5. If the filter element is blocked, it may be difficult or impossible to fully absorb the oil. In this case, the filter element can be cleaned or replaced.
6. The oil cooling fan is not turned on. Solution: turn on the cooling fan.
7. If the hydraulic oil does not meet the requirements or the viscosity of the oil is too high, please replace the low viscosity hydraulic oil that meets the label requirements.
8. There is hard concrete in the tank. If this happens, please clean and shovel it in time.
9. If the connection angle between the input flange and the universal drive shaft and the connection angle between the universal drive shaft and the power take-off is too large, noise will be generated when it is loose. If this happens, please check and tighten it in time
Good products make good services, and good manufacturers make good works. Since the loading mixer truck insists on providing customers with high-quality services, please continue to pay attention to our website for details: http://www.zkzsljbc.com