全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 常见问题 >

常见问题

自动上料搅拌车主机多长时间清理一次合适?

作者:http://www.zkzsljbc.com 时间:2021-07-16

1.各筒体,控制阀,电机按混凝土搅拌过程的要求运行,各筒体,控制阀,电机的控制必须准确,稳定,可靠。自上料混凝土搅拌车厂家它可装运由搅拌厂(站)生产的混凝土或按配比混合的骨料(砂、石子)、水泥和水,在运输过程中,不断对湿料慢慢搅拌,防止混凝土在运输过程中初凝和离析。
1. Each cylinder, control valve and motor shall operate according to the requirements of concrete mixing process. The control of each cylinder, control valve and motor must be accurate, stable and reliable. From the manufacturer of loading concrete mixer, it can transport the concrete produced by the mixing plant (station) or the aggregate (sand, stone), cement and water mixed according to the proportion. In the process of transportation, the wet material is continuously mixed slowly to prevent the initial setting and segregation of concrete in the process of transportation.
控制系统有自动和手动两种工作方式,它们相互独立,相互制约。
The control system has two working modes, automatic and manual, which are independent and restrict each other.
2.系统发展具有一个良好的抗干扰能力和完善的报警自保护管理功能;
2. The system has a good anti-interference ability and perfect alarm self-protection management function;
3.通过与计算机通讯,可以进行显示信息系统管理工作状态、故障报警;
3. Through the communication with the computer, it can display the management status of the information system and give an alarm;
自上料搅拌车
一个工作周期内搅拌车主机系统至少应清洗1次。每天可以生产活动结束后,则应对搅拌车主机信息进行比较全面的清洗,方法是:在清洗服务过程中,将水及少许石子放进搅拌主机内通过搅拌5~10min,清洗后将机内物料管理全部有效清除,不得有积水、积料;停机后再冲洗以及管道,清除搅拌罐内外环境灰尘和粘附的混凝土。一般这种情况下,搅拌设备主机之间加水约150~180kg左右,其他产品型号选择主机可据此分析增减,也可自备高压水枪或者进行数据清理。
The mixer host system should be cleaned at least once in a working cycle. At the end of daily production activities, the information of mixer host should be cleaned comprehensively. The method is as follows: in the process of cleaning service, put water and a little stone into the mixer host, and mix for 5-10 minutes. After cleaning, all materials in the mixer should be effectively removed without ponding and accumulation; After shutdown, the pipes and pipes shall be washed to remove the dust inside and outside the mixing tank and the adhered concrete. In general, about 150-180kg of water is added between the main machines of the mixing equipment. The main machines of other product models can analyze the increase or decrease according to this, and they can also provide their own high-pressure water gun or carry out data cleaning.
在冲洗搅拌主机料门时,应避免上部冲洗下的积料形成异物卡滞料门现象。搅拌过程中,若混凝土运输车较长时间没有到位(超过20~30min,尤其在夏季),应加水对搅拌机进行简易清洗。
When washing the material door of the main mixer, it should be avoided that the material accumulated under the upper part of the mixer will form a foreign body blocking the material door. In the process of mixing, if the concrete truck is not in place for a long time (more than 20-30min, especially in summer), water should be added to the mixer for simple cleaning.
搅拌车设备正常生产期间,要定期检查搅拌筒内及搅拌轴上混凝土的凝固情况,如有凝结应及时按要求进行人工铲除。人工清理搅拌筒前,必须切断电源、气路,放净余气、锁好控制室;人工清理搅拌筒时,严禁猛烈敲击搅拌轴、搅拌臂及搅拌叶片。
During the normal production of the mixer, the concrete setting in the mixing drum and on the mixing shaft should be checked regularly. If there is any setting, it should be removed manually in time according to the requirements. Before manually cleaning the mixing drum, the power supply and gas path must be cut off, the residual gas must be discharged, and the control room must be locked; When manually cleaning the mixing drum, it is strictly forbidden to strike the mixing shaft, mixing arm and mixing blade violently.
自动上料搅拌机用冲洗充电门,上部冲洗避免夹在充电门的现象形成的异物积累的材料时的搅拌主机设备。混合过程中,如果不再有在现浇混凝土卡车(超过20?30分钟,尤其是夏天),水应加入搅拌机,便于清洗。
Automatic feeding mixer with flushing charging door, upper flushing to avoid the phenomenon of clamping in the charging door formed by the accumulation of foreign materials when the mixing host equipment. During mixing, if there is no longer a truck in cast-in-place concrete (more than 20? 30 minutes, especially in summer), water should be added to the mixer for easy cleaning.
自上料搅拌车今日就给大家带来这些精彩内容,更多的精彩内容请点击:http://www.zkzsljbc.com进行详情查看,我们后续会有更多精彩内容等您
Since the feeding mixer, we have brought you these wonderful contents today. For more wonderful contents, please click: http://www.zkzsljbc.com Check the details, we will have more wonderful content waiting for you
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码

微信号:1234567

点击微信号复制,添加好友

 打开微信