1. First of all, the specifications of the car body must meet the requirements of, and the main parameters of the specifications shall comply with the public notice.

2. 对于外协件及外购件必须要有生产厂的出厂合格证，而且要符合相关的标准要求，需要经过混凝土搅拌车生产商的检查，达标后才能使用。

2. For the outsourcing parts and purchased parts, the factory certificate of the manufacturer must be provided, and the relevant standard requirements shall be met. The inspection of the concrete mixer manufacturer shall be carried out before they can be used.

3. 3m3混凝土搅拌车的生产商加装的混凝土搅拌车的总质量不能超出公示容许的高值，转向轴载质量和侧倾平稳角应符合相关的要求。

3. The total mass of the concrete mixer truck installed by the manufacturer of 3m3 concrete mixer truck shall not exceed the high value allowed by the public notice, and the steering axle load mass and roll stable angle shall meet the relevant requirements.

4. 3m3混凝土搅拌车储罐的焊接要均匀分布、竖直，表面无毛刺、包砂、裂缝等现象。

4. The welding of 3m3 concrete mixer tank shall be evenly distributed and vertical, and the surface shall be free of burr, sand and crack.

5. 对于所有露出的金属，表面必须做防锈，车体外形及裝饰应别具一格，符合相关的要求。

5. For all exposed metal, the surface must be antirust, and the body shape and decoration should be unique and meet the relevant requirements.

6.3m3 混凝土搅拌车从进料到输送机倒料结束，容许的久时间不能超出80分钟，而且罐车按照规定持续运送不超300转，混凝土搅拌车在行车的过程中时速不可超过60/h。

The allowable time of 6.3m3 concrete mixer from feeding to the end of conveyor dumping shall not exceed 80 minutes, and the continuous transportation of tank truck shall not exceed 300 revolutions according to the regulations. The speed of concrete mixer truck during driving shall not exceed 60 km / h.

7. 装进的预拌混凝土必须在要求的时间内长途运输到供货地方，混泥土的质量必须符合的标准。

7. The ready mixed concrete must be transported to the place of supply in a long distance within the required time, and the quality of concrete must meet the standard.

8. 入料口的出口处规格不可少于600毫米,间距路面间距不可超过3.9米。

8. The size of the outlet of the feed inlet shall not be less than 600mm, and the distance between the pavement and the pavement shall not be more than 3.9m.

9. 3m3混凝土搅拌车的入料速度不能少于2.6m?/mln，进料速度需超过0.65m?/mln，进料料的残存率在2%-5%之间。

9. The feeding speed of 3m3 concrete mixer should not be less than 2.6m? / mln, the feeding speed should be more than 0.65M? / mln, and the residual rate of feeding material should be between 2% and 5%.

5. 车子的各构件安裝必须坚固，各接入部分不能有受损、形变等现象。

5. All components of the vehicle must be installed firmly, and the access parts shall not be damaged or deformed.

4. 在车子大总质量的情况下，在坡道上行车不能有混泥土外流现象。

4. Under the condition of large total mass of the vehicle, there should be no concrete outflow when driving on the ramp.

12. 车子的制动系统必须符合的要求，车子的排污还要符合的标准。

12. The brake system of the car must meet the requirements, and the emission standard of the car should also meet.

13. 车体的每一项密封性性能必须良好，各个突面、管接头及所有的接入部位均不可有渗水现象。

13. Each sealing performance of the car body must be good, and no water seepage is allowed on all protruding surfaces, pipe joints and all connecting parts.

以上就是今天小编为大家介绍关于自动上料搅拌车的相关的资讯，您可以及时的关注我们的网址：http://www.zkzsljbc.com查询了解更多的详情咨询,我们会有更多的精彩内容为您呈现.

The above is today's small editor for you about the automatic feeding mixer related information, you can timely pay attention to our website: http://www.zkzsljbc.com Inquiry for more details, we will have more wonderful content for you