全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 常见问题

常见问题

自上料搅拌车在出车准备装料时应该注意什么?

作者:http://www.zkzsljbc.com 时间:2020-09-10

1、细心检查及时发现排除故障。
1. Check carefully, find and remove the fault in time.
千万不能让自动上料搅拌车坏在路上,否则出现闷罐就麻烦了,混凝土一般停罐不能超过2个小时,C40往上级别的混凝土基本就不能停。点火之前先检查机油、防冻液、润滑油和冷却水等,发现不足时,应重新进行添加。车子启动后,再让罐子低速旋转,围绕着车检查轮胎气压,是否有漏气的胎,再用螺丝刀剔掉在胎缝里的石子,检查是否有铁钉之类扎在胎里!
Do not let the automatic feeding mixer truck break down on the road, otherwise it will be troublesome for the tank to be blocked. Generally, the concrete can not be stopped for more than 2 hours, and the concrete with C40 grade can not be stopped basically. Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, and add them again if they are insufficient. After the car starts, let the jar rotate at a low speed. Check the tire pressure around the car to see if there is a leaking tire. Then use a screwdriver to remove the stones in the tire seams and check whether there are iron nails stuck in the tire!
再检查灯光,尤其是腰灯,务必保证照着轮胎边缘,工地会经常乱堆放钢筋之类的东西,而胎侧是薄弱的。用抹布擦干净两边的后视镜,窗户玻璃,工地路况复杂,光线不好,视线一定要保证!
Check the light again, especially the waist lamp, and make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is the weakest. Clean the rear-view mirror and window glass on both sides with dishcloth. The road conditions on the construction site are complex and the light is not good. The line of sight must be guaranteed first!
自上料搅拌车
2、保证水箱里有足够的水,有减水剂,因各种原因料太干,没有水添加放不出料的时候,减水剂就是救命稻草了。
2. To ensure that there is enough water in the water tank, there are water reducing agents. Because of various reasons, the material is too dry. When there is no water to add and discharge, the water reducing agent is a lifesaving straw.
3、确认搅拌罐处于停止状态,因为发动机启动时万一罐子处于高速旋转状态,瞬间的力会很大的,伤减速机。
3. Make sure that the mixing tank is in the stop state, because if the tank is in high-speed rotation state when the engine is started, the instantaneous force will be very large and damage the reducer.
4、无论是将手柄从搅拌到排放还是从排放到搅拌,都应使其停止在停止位置,然后拨到下一个操作位置。
4. Whether it is from mixing to discharging or from discharging to mixing, the handle should be stopped at the stop position and then moved to the next operation position.
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码