全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 行业资讯

行业资讯

自上料搅拌车装料时要注意清洁

作者:http://www.zkzsljbc.com 时间:2022-10-07

由于混凝土会在短时间内凝固成硬块,且对钢材和油漆有一定的腐蚀性,所以每次使用自上料搅拌车后,洗净粘附在自上料搅拌车及进出料口上的混凝土是每日维护必做的,下面小编来讲讲相关的清洁工作。
As the concrete will solidify into hard blocks in a short time, and has a certain corrosivity to steel and paint, it is necessary to clean the concrete adhered to the self loading mixer and the inlet and outlet every time after using the self loading mixer. The following section will talk about the relevant cleaning work.
自上料搅拌车一般露天停放,装料前先将罐里的积水和树叶之类的杂物排出,以免影响混凝土质量。
Generally, the self loading mixer is parked in the open air. Before loading, the accumulated water in the tank and sundries such as leaves shall be discharged to avoid affecting the concrete quality.
在装料的同时向随车自带的清洗用水水箱中注满水;
At the same time of loading, fill the water tank with water for cleaning;
装料后冲洗进料口,洗净进料口附近残留的混凝土;
Flush the feed inlet after loading, and clean the residual concrete near the feed inlet;
到工地卸料后,冲洗出料槽,然后向自上料搅拌车内加清洗用水30—40L;在车辆回程时保持自上料搅拌车正向慢速转动;
After unloading at the construction site, flush the discharge chute, and then add 30-40L of cleaning water to the charging mixer; Keep the self feeding mixer turning slowly in the forward direction when the vehicle returns;
下次装料前切记放掉自上料搅拌车内的污水;
Remember to discharge the sewage from the loading mixer before the next loading;
自上料搅拌车
每天收工时清洗自上料搅拌车及进出料口周围,保证不粘有水泥及混凝土结块。
Clean the area around the feeding mixer truck and the inlet and outlet at the end of each day to ensure that there is no cement and concrete caking.
洗完后要关掉水箱进气口,打开水箱排气口排掉气体,因为气压下,水管连接不好的地方,容易渗水,影响其他车辆的。再次检查轮胎是否卡有石子铁钉等杂物,使用工具及时清理,因为停车时轮胎与地面接触的地方是检查不到的。
After washing, close the air inlet of the water tank and open the air outlet of the water tank to discharge the gas. Because the water pipe is not well connected under air pressure, it is easy to seep water and affect the safety of other vehicles. Check whether there are stones, nails and other sundries stuck in the tire again, and use tools to clean them in time, because the contact between the tire and the ground cannot be checked when parking.
以上就是对自动上料搅拌车清洗维护的要点介绍,以上这些工作只要一次不认真进行,就会给以后的工作带来很大的麻烦,所以希望大家重视自动上料搅拌车的清洗。更多相关实现就来我们网站http://www.zkzsljbc.com咨询看看吧!
The above is the key introduction to the cleaning and maintenance of the automatic feeding mixer. As long as these works are not carried out carefully once, they will bring great trouble to the future work. So I hope you can pay attention to the cleaning of the automatic feeding mixer. More related implementations come to our website http://www.zkzsljbc.com Consult!
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码