在自上料搅拌车的日常使用中，如果混凝土凝固在搅拌车里面，会很大程度上影响到自上料搅拌车的正常作业。两种方法把搅拌车内凝结混凝土清理走，分别为：

In the daily use of the self loading mixer, if the concrete solidifies in the mixer, it will greatly affect the normal operation of the self loading mixer. There are two methods to remove the condensed concrete in the mixer:

方法一：

Method 1:

1、准备好紧急驱动软管，将故障混凝土自上料搅拌车熄火，卸下液压马达上的高压油管接头。

1. Prepare the emergency drive hose, turn off the faulty concrete from the loading mixer truck, and remove the high-pressure oil pipe connector on the hydraulic motor.

2、将救援车熄火，将其液压马达的高压油管卸下，并与故障车上的对应接头用紧急驱动软管相连。

2. Turn off the rescue truck, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the faulty truck with the emergency drive hose.

3、发动救援车，将其操纵手柄拨出料位置，故障车内的商品混凝土即被排出。

3. Start the rescue truck and turn its operating handle to the discharge position, and the commercial concrete in the faulty truck will be discharged.

4、紧急驱动完毕后，将驱动软管卸下，并恢复两车原状。

4. After the emergency drive is completed, remove the drive hose and restore the two vehicles to their original state.

方法二：

Method 2:

1、若方法一实行有困难，则须采用以下方法，立即排出混凝土。

1. If the method is difficult to implement, the following methods must be used to discharge the concrete immediately.

2、在托轮和滚道之间放入木楔，以控制搅拌罐的旋转，这时一定要注意。

2. Put wooden wedges between the supporting wheel and the raceway to control the rotation of the mixing tank, and pay attention to safety at this time.

3、将发动机熄火，拆松液压马达的一根高压油管，搅拌罐可自由旋转，控制搅拌罐的旋转，使维修孔转到下部，然后打开维修孔，清理出罐内混凝土。

3. Turn off the engine, loosen a high-pressure oil pipe of the hydraulic motor, the mixing tank can rotate freely, control the rotation of the mixing tank, make the maintenance hole turn to the lower part, then open the maintenance hole, and clean out the concrete in the tank.

4、此时一定要注意，商品混凝土排出完毕后，恢复自上料搅拌车原状。

4. At this time, attention must be paid to safety. After the commercial concrete is discharged, it shall be restored to the original state of the loading mixer truck.

混凝土凝结在搅拌罐里面的原因有很多，除了没有及时清洗搅拌罐外，其中主要是搅拌车发动机不能运作，没有动力输入液压机而招致液压机中止工作，使得装料罐不能转动而让混凝土凝结在搅拌车罐里面，所以要及时做好清理。更多相关事项就来我们网站http://www.zkzsljbc.com咨询！

There are many reasons for concrete condensation in the mixing tank. In addition to the failure to clean the mixing tank in time, the main reason is that the engine of the mixer truck cannot operate, and the hydraulic machine stops working due to the lack of power input, which makes the charging tank unable to rotate and allows concrete condensation in the mixing tank. Therefore, it is necessary to clean it in time. Come to our website for more information http://www.zkzsljbc.com consulting service