全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 行业资讯

行业资讯

自上料搅拌车在维修中注意的事项

作者:http://www.zkzsljbc.com 时间:2022-11-07

自上料搅拌车的使用时间过长非常容易就会出现问题,所以需要固定时期内去进行维修,那么您知道在维修中要注意什么事情吗?
If the self feeding mixer is used for too long, it is very easy to have problems, so it needs to be repaired within a fixed period of time. Do you know what to pay attention to in the maintenance?
在初次使用到50小时时,要及时检查罐体及其他部位螺栓是否有松动,每天行车前要检查托轮与滚道的润滑,每个月打开一次托轮护罩,清理内部的油污并添加润滑油脂。
When the first use lasts for 50 hours, timely check whether the bolts on the tank body and other parts are loose. Before driving every day, check the lubrication of the supporting wheel and raceway. Open the supporting wheel shield once a month, clean the internal oil stain and add lubricating grease.
自上料搅拌车设备在长时间的使用中难免会存在一定的故障问题,为了避免设备在使用中的良好性能,就需要我们对设备进行合理的维修才行。
It is inevitable that the self feeding mixer equipment will have some problems in the long-term use. In order to avoid the good performance of the equipment in use, we need to carry out reasonable maintenance on the equipment.
液压系统是搅拌车的核心系统。为保证搅拌车能正常工作,搅拌罐能运转正常,须在每次车辆发动前检查油路散热器和减速机的液压油位,保证油位指示在视窗范围内。同时要保证它的清洁,不能让灰尘等污染系统液压油,造成系统不能正常工作或损坏。
Hydraulic system is the core system of mixer truck. In order to ensure that the mixer truck can work normally and the mixing tank can operate normally, the hydraulic oil level of the oil radiator and reducer must be checked each time before the vehicle is started to ensure that the oil level indication is within the scope of the window. At the same time, ensure that it is clean, and do not allow dust and other pollutants to pollute the hydraulic oil of the system, causing the system to not work normally or be damaged.
自上料搅拌车
气压供水系统加水量好在水箱的四分之三处,经常检查阀体是否堵塞或是否有工作异常。在有结冰可能的环境中使用时,供水系统须排空存水,防止管路冻裂。
The amount of water added to the pneumatic water supply system is good at three quarters of the water tank. Check the valve body frequently for blockage or abnormal operation. When the water supply system is used in an environment with the possibility of icing, the water storage must be drained to prevent the pipeline from freezing.
不能够给自上料搅拌车的轮胎栓螺母涂油,不少司机认为给轮胎栓螺母涂润滑油能够避免螺栓螺母生锈,事实上,这种做法是非常危险的,因为它会给搅拌车行车带来隐患。
It is not allowed to oil the tire bolts and nuts of the self loading mixer. Many drivers think that coating the tire bolts and nuts with lubricating oil can prevent the bolts and nuts from rusting. In fact, this practice is very dangerous, because it will bring hidden dangers to the driving of the mixer.
螺栓和螺母拧紧之后本身是有自锁特点的,而润滑油则会让自锁系数下降。搅拌罐运作过程中,螺栓螺母一旦松动就会产生事故。
Bolts and nuts have self-locking characteristics after being tightened, while lubricating oil will reduce the self-locking coefficient. During the operation of the mixing tank, once the bolts and nuts are loosened, accidents will occur.
自上料搅拌车在维修中注意的事项就是以上所讲解的部分内容了,其他事项就让您http://www.zkzsljbc.com使用中自行了解吧!
The matters needing attention in the maintenance of the self feeding mixer truck are just some of the contents explained above http://www.zkzsljbc.com Learn by yourself in use!
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码