全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 行业资讯 >

行业资讯

搅拌车油耗降到较低这些妙招你学会了吗?

作者:http://www.zkzsljbc.com 时间:2021-09-24

1、在行驶中发现搅拌车现在的滑行距离明显减少,这时司机们应该检查一下搅拌车的轮胎气压是否合乎气压标准。若轮胎充气不足,耗油量也会增加。
1. During driving, it is found that the sliding distance of the mixer truck is significantly reduced. At this time, the drivers should check whether the tire pressure of the mixer truck meets the air pressure standard. If the tire is under inflated, the fuel consumption will also increase.
提示:适时为轮胎充足气。
Tip: fill the tire in time.
2、检查搅拌车轮胎的磨损程度,如果轮胎磨损严重时,就会经常出现打滑现象,增加耗油量。
2. Check the wear degree of the mixer tire. If the tire is seriously worn, it will often slip and increase the fuel consumption.
提示:必要时可更换的轮胎。
Tip: replace the tire if necessary.
3、在搅拌车行驶中或启动时发现车轮有异常响声,网友们应该及时检查轴承及刹车系统是否有故障。如果车轮转动不正常,就会影响搅拌车的车速,使油耗加大。
3. If abnormal noise is found on the wheels when the mixer is driving or starting, netizens should timely check whether the bearing and braking system are faulty. If the wheels rotate abnormally, it will affect the speed of the mixer and increase the fuel consumption.
自上料搅拌车
提示:检修轴承及刹车系统。
Tip: repair the bearing and brake system.
4、搅拌车离合器打滑会使发动机的转数丢失。当您在急加速时发现搅拌车发动机转速表增加很快,但车速增加却很慢,这时可以判定是离合器打滑了。
4. If the mixer clutch slips, the number of revolutions of the engine will be lost. When you accelerate rapidly, you find that the engine tachometer of the mixer truck increases rapidly, but the speed increases slowly. At this time, you can judge that the clutch is slipping.
提示:需要更换离合器片,离合器压盘和驱轮。
Note: the clutch plate, clutch pressure plate and drive wheel need to be replaced.
5、当搅拌车已经行驶二三十万公里时,通常会出现汽缸压力不足的现象,这时油耗会明显增加。
5. When the mixer has been running for 200000-300000 km, the cylinder pressure is usually insufficient, and the fuel consumption will increase significantly.
提示:如果真的出现这种故障,那么搅拌车发动机就需要大修了。
Tip: if this kind of fault really occurs, the mixer engine needs to be overhauled.
6、当排气管出现冒黑烟、油耗增D的现象时,需要检查化油器。
6. When the exhaust pipe emits black smoke and the fuel consumption increases D, it is necessary to check the carburetor.
提示:如果化油器太脏可以用清洗剂直接向化油器进气口喷一喷,若此时还冒黑烟,那只能把化油器拆开清洗了。
Tip: if the carburetor is too dirty, you can spray the cleaning agent directly into the carburetor air inlet. If there is still black smoke at this time, you can only disassemble the carburetor for cleaning.
7、如果搅拌车火花塞使用的时间太长,也会出现油耗加大的现象。因为搅拌车火花塞损坏会使点火的N量下降,车提速减慢,导致油消耗明显增加。
7. If the spark plug of the mixer is used for too long, the fuel consumption will also increase. Because the damage of the spark plug of the mixer truck will reduce the amount of ignition N and slow down the speed-up of the truck, resulting in an obvious increase in oil consumption.
提示:应该换搅拌车火花塞了。
Tip: it's time to change the spark plug of the mixer.
8、当搅拌车的温控开关和节温器损坏时,会出现油耗增加的现象。因为搅拌车的温控开关和节温器损坏会使水温降低,化油器不能正常工作,导致搅拌车油雾化不好,油耗量明显增加。
8. When the temperature control switch and thermostat of the mixer are damaged, the fuel consumption will increase. Because the damage of the temperature control switch and thermostat of the mixer will reduce the water temperature and the carburetor can not work normally, resulting in poor oil atomization and obvious increase in oil consumption.
以上就是小编为您提供的关于自上料搅拌车 的知识,更多的精彩内容请您继续关注我们的网站:http://www.zkzsljbc.com,我们会有更多对的精彩内容 为您分享.
The above is the knowledge about self loading mixer provided by Xiaobian. Please continue to pay attention to our website for more wonderful contents: http://www.zkzsljbc.com , we will have more wonderful content for you to share
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码

微信号:1234567

点击微信号复制,添加好友

 打开微信