一、采购的新车初驶期间都不要速度过快，速度在40-60;而且利用发动机转速表和车速表，使搅拌车发动机转速和车速都在中速以下行进。
1、 When purchasing new cars, don't drive too fast. The best speed is 40-60km; Moreover, the engine speed and vehicle speed of the mixer are all below the medium speed by using the engine tachometer and speedometer.
二：搅拌车用油也要留意：搅拌车新车所运用的机油用厂家指定的机油。搅拌车发动后要等几分钟后在行进，待水温抵达必定的温度后在加快。驾驭中要挑选平稳路面，保持中速行进，劲量不要急加快和急刹车，油门轻踏、操作也要轻，一起还要随时留意发动机的声响和温度。
2： Also pay attention to the oil used in the mixer: the oil used in the new mixer is the best oil specified by the manufacturer. After the mixer starts, it needs to wait a few minutes before moving, and it will speed up when the water temperature reaches a certain temperature. In driving, you should choose a smooth road surface, keep a medium speed, don't speed up and brake quickly, step on the accelerator lightly, operate lightly, and pay attention to the sound and temperature of the engine at any time.
三：搅拌车不要采纳紧迫刹车:避免搅拌车底盘和发动机的负荷过大，所以在开始行进的几百内不要加快和急刹车。如有突发状况，要先踩下离合器踏板，在刹车
3： Don't adopt emergency braking for mixer: avoid overload of mixer chassis and engine, so don't speed up and brake abruptly in the first few hundred kilometers. If there is an emergency, first step on the clutch pedal, and then brake

四：搅拌车新车满载会对机身车件形成损坏:在开始的一千内，搅拌车不要装的太满，等新车跑完磨合期就好了，假如满载会使发动机继续工作的时刻增加，形成机件磨损，新车在没跑完磨合期不宜行进的时刻过长。
4： The full load of the new mixer will damage the parts of the fuselage: in the first 1000 kilometers, the mixer should not be too full, just wait until the new car runs through the running in period, if the full load will increase the time for the engine to continue to work, forming the wear of the parts, and the new car should not travel too long before it runs through the running in period.
五：搅拌车行车时要实时换挡:先用低挡起步，跑2里路后在换入高挡，行车中搅拌车水温不宜过高。控制在恒温，在行进中要实时换挡，不要长时刻运用一个挡位，尽量不要运用高挡低速行进和低挡高速行进。换挡要从低转速高转速要先工作一段时刻，转速不要高出4000转，每个挡位的转速都要跑到，高速状态下要力度适中、匀称地踏刹车踏板，直到车速下降。跑到必定数就要定时养护，机油要用好一点的，往后跑到必定的数再依据搅拌车的需要在做养护。
5： When the mixer is driving, it is necessary to shift gears in real time: start at low gear first, run for 2 miles and then shift into high gear. The water temperature of the mixer should not be too high during driving. The best control is at constant temperature. You should shift gears in real time when you are moving. Don't use one gear for a long time. Try not to use high gear and low speed or low gear and high speed. To shift gears from low speed to high speed, you need to work for a period of time first. The maximum speed should not be higher than 4000 rpm. The speed of each gear should run. At high speed, you should step on the brake pedal moderately and evenly until the speed drops. After running for a certain number of kilometers, it is necessary to maintain regularly. The engine oil should be used better. After running for a certain number of kilometers, it is necessary to maintain according to the needs of the mixer.